|
 |
|
Whether you
are cutting cable for routine procedure or
wishing to avoid hazardous hands on
operations the 80mm cable cutter is the
ideal tool.
The 80mm cable cutter has been
specifically design for telecoms cable
applications to provide efficient first
time cuts time and time again on cables up
to 80mm. |
|
|
 |
|
Introduction
|
|
The 80mm Cable
Cutter has been engineered specifically to
enhance ship board safety and operational
efficiency.
The unit can be used in either remote mode
during recovery conditions or for emergency
cable cut, and for routine cable cutting
during normal service operations. |
|
|
|
|
|
|
Enhanced Safety
|
|
During cable
recovery operations the 80mmCable Cutter can
be attached to the cable bight before tension
transfer and removal of the Grapnel. In doing
so the cable can cut remotely (up to 20m)
removing the need for personnel to be handling
the cable during this hazardous part of the
operation.
Cutting the cable takes less than a minute
depending on the cable type. Once cut the
cable can be recovered leaving the cutter on
the deck to retrieved at a later time. |
|
|
|
|
Emergency Cut
|
|
Due to its
design, the cable cutter can be fitted to the
cable at any stage during the operation. In
addition the cable can be hauled through the
cutter should the need exist. In doing so the
cutter can pre-positioned on the cable should
the vessel need to cut and discharge the cable
under an emergency condition. |
|
|
|
|
Routine Cutting
|
|
The 80mm Cable
Cutter utilises the latest tool steel to
provide superb robustness and durability. The
end result is cutter which can be used time
and time again without the need to replace key
components such as the blade or bar.
When the blade does finally show signs of
wear, instead of replacement the blade can be
re-ground and re-used a number of times. |
|
|
|
|
|
|
|
|
Versatility
|
|
The cutter can be
fitted with most commonly used hydraulic
connections making it ultimately adaptable for
nearly all types of hydraulic supplies.
Typically the cutter is used in connection
with the electric hydraulic pump supplied as
part of the UJ equipment reducing the need to
carry additional equipment and cost. |
|
|
|
